Pinterest Challenge: Chevron Entry Wall

I’ve been looking forward to the Pinterest Challenge all week!

It’s given me the motivation I needed to tackle a project I’ve been contemplating for a while. You may have noticed it in my To Do List:

{source}

I’ve been obsessed with this whole home for a while, but I especially loved the entry. I knew I wanted to create a feature wall for ours, but wasn’t quite sure how I wanted to go about it. I didn’t want to buy wallpaper or a stencil (I’d rather spend my budget elsewhere) so I needed a pattern simple enough to tackle with painter’s tape. I thought about squares, diamonds, stripes… But ultimately, chevron won out. It’s only paint! I decided that if I really found it too bold, I could simply paint over it.

Here’s how we left off after I created a landing strip in our entry way:

Entry Before

(As a side note: I wouldn’t have kept that carpet in the entry anyway, but my dog literally ATE HALF OF IT. I was not impressed!)

My inspiration was a great AT House Tour, but unfortunately they don’t explain how the chevron wall was created, besides of course painter’s tape, a level and whole lot of patience!

Here’s how I did it:

Tools required:

Frog Painter’s Tape (that stuff is GOLD)

A level

A pencil

Measuring tape

Exacto knife

Paint

Paint brush

Small roller (optional)

1. Each chevron side is 1′ long. To start off, I used my level at a 45 degree angle. I then used it to trace a line, and pasted my tape along the line. I didn’t need to worry much about the length, because I could trim that off later.

2. Then, I created one strip of the zig zag from one side of the wall to the other, following the same process as above. This was the most difficult part, as from here on out, I followed this pattern. Unfortunately I didn’t take any photos of this part since it was definitely trial and error!

3. To do the next strip, I used the roll of tape to measure the distance I would need between the zig zag and marked it with a pencil.

Measure the distance

2. Using my pencil mark as a guide, I then traced a line using my level.

Trace

4. Following the line I traced, I pasted my frog tape.

Follow

Here’s what it looked like at this point:

Taped down

As a quick tip: It’s best to have each piece overlapping. That way, you can follow the line of the opposite piece of tape with the exacto knife instead of having to free hand your cut. For example, in this picture, I would have been better off going with slightly longer strips.

6. From there, I cut off the excess with an exacto knife, so it looked like this.

Trimmed

Here’s the progress!

Progress 

I literally just continued that way for the entire wall. I didn’t need to worry too much about the corners lining up: as long as the tape was at the right angle and the right distance away from the previous strip, the lengths and points lined up.

7. Once all taping is finished, run down each edge of tape with a credit card to avoid air bubbles. This was a crucial step.

8. Begin painting! We (i.e. Shaun) did the first coat with a paint brush to avoid extra paint from seeping under the tape.

First coat

9. We let that one dry overnight, and tackled the next one with a small roller brush (a “whiz” if you’re curious to know the term of the trade!)

Here’s how it turned out!

Chevron wall

I’m so happy with the results! I was nervous at first… Kind of like when you dye your hair and it takes a while to get used to such a drastic change?

Chevron closeup

I am so impressed with the frog tape. It left such crisp lines!

Final Chevron

I’m so happy with the results! Eventually I’ll buy a mirror that fits the space better, but for now, I’m over the moon!

How did your Pinterest Challenge go? Did it end up leaving a mess in every other part of your house like me? I can’t wait to see them!

I’m also linking up with: